Nissan Primera

1990-1992 of release

Repair and operation of the car



Nissan Primera
+ Cars of the Nissan Primera brand
+ Current leaving and service
+ Engine
+ Cooling system and heating
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Manual transmission, differential and main transfer
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   General information
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks - the general information
   Fusible inserts (thermal relays) - the general information
   Chain breakers (thermal relays) - the general information
   The relay - the general information
   Headlights
   Explanatory remarks to schemes of electric connections
+ Appendices



Headlights

Adjustment

Both adjusting screws of a headlight are shown on illustrations below. Apparently from illustrations there is a difference between a headlight with adjustment of the direction of a beam or without it. Headlights have to be regulated by means of optical devices, only as a last resort it is possible to adjust them make-shifts.

Position of screws of adjustment of a headlight without system of adjustment of an inclination of a beam.
Position of screws of adjustment of a headlight with system of adjustment of an inclination of a beam.

 PERFORMANCE ORDER

  1. If the emergency adjustment is undertaken, install the car in 5 meters from a wall or gate of a garage and draw the chart shown on an illustration below. Adjust headlights so that the average point of a light bunch at the turned-on driving beam of N to a wall was approximately at the same height, as an average point of a headlight. Turn on passing beam and to apply light border on about 65 mm below the mentioned light center.

Chart of adjustment of headlights. The size between shooters at the left above at the Primera models has to make 65 mm

H — height of headlights
WL — distance between headlights
P — average points of headlights

  1. To adjust a beam across, rotate the screw shown on the right to regulate a beam down, rotate the screw shown on the left side.
  2. Before regulating headlights, in tires it is necessary to create pressure meeting Specifications.
  3. Install the car on a plain surface, the tank has to be filled. As it was already mentioned, the described adjustment only belt.
  4. At the first possibility of a headlight it is necessary to check and adjust optical devices.

Replacement of lamps in headlights

Replacement of lamps in headlights is carried out from a reverse side of a headlight in a motive compartment.

 PERFORMANCE ORDER

  1. After shutdown of the plug remove a cap. For this purpose press a cap inside and turn to the left.
  2. Squeeze lock springs of a lamp and take out it. Do not touch a new lamp naked fingers.
  3. You make replacement as soon as possible that on a reflector dust through an opening from a lamp could not get.
  4. Establish a cap in the return sequence.
  5. Connect the plug.
  6. In conclusion check adjustment of headlights and if necessary adjust in a workshop, or temporarily adjust as it was described in the Head Kuzov.